Installation Sheet

2Toilet Installation Instructions
INSTALLATION
4. Set the toilet down on the floor and press in place to form a
tight seal with the wax ring. Do not move the toilet after
placement, this could break the watertight seal and cause
leakage.
5. Thread the washers and nuts onto the anchor bolts.
Tip: Before tightening washers and nuts, verify that your toilet is level. If
the toilet is not level place a shim under the base of the toilet and adjust as
necessary.
6. When toilet is properly aligned, finish tightening the
washers and nuts onto the anchor bolts with your adjustable
wrench. Do this gradually, alternating from one bolt to the
other until both are tight. Be sure not to overtighten as this
could cause cracks and damage the base of your toilet.
7. Place bolt caps over the anchor bolts on the base of the
toilet.
Tip: If the anchor bolts extend too far over the top of the washers and nuts,
use a hacksaw to trim to the correct length.
8. If you are installing a two piece toilet, slide the tank bolts
through the mounting holes on the top of the base of the
toilet. If your toilet has only one piece, move on to step 9.
9. Thread washers and nuts onto the tank bolts. Verify that the
tank is level and alternately tighten the washers and
nuts until the tank is resting firmly on the bowl.