Installation Sheet

2Toilet Installation Instructions
INSTALLATION
TOILET INSTALLATION INSTRUCTIONS
1. Press the new wax ring into place on the toilet flange on
the floor with the flat side down and the tapered edge up.
Apply enough pressure to hold the ring in place during
installation but be careful not to press it out of shape.
2. Install the anchor bolts through the toilet flange. The
anchor bolts should be pointing upwards so that when the
toilet is placed the bolts will project through the mounting
holes on the base of the toilet.
3. When the wax ring and bolts are attached, lift the toilet
and align the mounting holes with the anchor bolts on the
floor for proper placement.
4. Set the toilet down on the floor and press in place to
form a tight seal with the wax ring. Do not move the
toilet after placement, this could break the watertight
seal and cause leakage.
5. Thread the washers and nuts onto the anchor bolts.
Tip: Before tightening washers and nuts, verify that your toilet is
level. If the toilet is not level place a shim under the base of the toilet
and adjust as necessary.
6. When toilet is properly aligned, finish tightening the
washers and nuts onto the anchor bolts with your
adjustable wrench. Do this gradually, alternating from
one bolt to the other until both are tight. Be sure not to
overtighten as this could cause cracks and damage the
base of your toilet.