Installation Sheet

ManualsBrandsSignature Hardware ManualsBathroom FaucetsKnox Single Hole Waterfall Bathroom Faucet with Pop-Up Drain Assembly

1Knox Single Hole Faucet Installation Instructions

KNOX SINGLE HOLE FAUCET INSTALLATION

GETTING STARTED

TOOLS AND MATERIALS:

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

faucet, plumbing, sink, counter top, or for personal injury

during installation.

Observe all local plumbing and building codes.

Unpack and inspect the faucet for shipping damage. If

any damage is found, contact our Customer Relations

team at 1-866-855-2284.

Ensure that you have gathered all of the required

materials that are needed for the installation.

For these instructions, it is assumed that the old faucet

has been completely removed and any necessary

repairs or modiﬁcations to the water supply have been

completed.

Plumber’s Tape

Basin Wrench

Thread Sealant

Adjustable

Wrench

Small

Bucket

SKU(s): 927743, 931430

Summary of content (5 pages)

PAGE 1
SKU(s): 927743, 931430 KNOX SINGLE HOLE FAUCET INSTALLATION BEFORE YOU BEGIN TOOLS AND MATERIALS: We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation. Plumber’s Tape Basin Wrench Thread Sealant Observe all local plumbing and building codes. Unpack and inspect the faucet for shipping damage.
PAGE 2
KNOX SINGLE HOLE FAUCET INSTALLATION INSTALLATION 1. Ensure that the water supply below your sink is completely shut oﬀ by turning the valve all the way to the right. 3. Attach the provided braided water lines to the faucet. Tighten ﬁrmly, but be careful not to overtighten. Tip: Place a small bucket below your workspace to catch any water that may drip during the installation process. OFF 2. Remove the lock nuts, metal washer, and rubber gasket from the threaded mounting posts on the faucet spout. 4.
PAGE 3
KNOX SINGLE HOLE FAUCET INSTALLATION 5. Secure the faucet by threading the lock nuts back onto the faucet until hand tight. Finish tightening using a basin wrench. 7. Once installation is complete, turn the main water supply back on from underneath your sink. Check for any leaks underneath. ON 6. Apply plumber’s tape or thread sealant to the threading on each braided water line. Attach the water lines to your main water supply lines. Ensure that you are connecting the hot and cold lines appropriately.
PAGE 4
KNOX SINGLE HOLE FAUCET INSTALLATION DRAIN INSTALLATION 1. Dissasemble the drain assembly and lay the parts aside, in the same order they were removed. See the illustration below as a reference if needed. 2. Apply plumber’s tape to the threading on the tailpiece, then reattach the tail piece to the pop-up drain ﬂange. Pop-Up Drain Flange Flat Rubber Gasket Tapered Rubber Gasket Plastic Friction Washer Lock Nut 3.
PAGE 5
KNOX SINGLE HOLE FAUCET INSTALLATION 4. Insert the drain ﬂange and tailpiece through the top of your sink’s drain hole. 6. Thread the lock nut onto the drain ﬂange. Hand tighten until secure, then ﬁnish tightening with a basin wrench once the drain is properly aligned. Important: Be careful not to overtighten, which could crack a porcelain sink or stone countertop. COUNTERTOP COUNTERTOP COUNTERTOP COUNTERTOP 5.