Installation Sheet
1Newman Outdoor Shower Panel and Tray Installation Instructions
NEWMAN OUTDOOR SHOWER PANEL AND TRAY
INSTALLATION INSTRUCTIONS
Before installing, read entire installation instructions. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer
Service at 1.866.855.2284. If you need assistance or have questions while installing your shower panel, contact
Customer Service. We recommend consulting a professional if you are unfamiliar with installing outdoor or plumbing
xtures. Signature Hardware accepts no liability for any damage to the shower, installation surface, or for personal injury
during installation.
TOOLS AND MATERIALS:
INSTALLATION
1. Lay the shower panel down at so that all parts can be easily viewed and accessed during assembly. Line up the
mounting holes on the shower column and tray.
2. Place the reinforcement plate on the bottom of the tray in line with the mounting holes.
3. Insert the assembly bolts through the plate, tray and mounting holes in the shower column. Thread the washers and
nuts onto the bolts, and tighten with the appropriate wrench.
4. Set the shower panel in the desired installation location. If necessary, adjust the shower by tightening the levelers on
the bottom of the tray.
5. Insert the shower arm into the tting in the panel and twist to tighten. Finish tightening with an adjustable wrench. Wrap
a dry cloth around the shower arm to protect the nish while tightening.
6. Thread the shower head onto the arm and hand-tighten.
7. Attach the hand shower hose to the outlet on the side of the shower panel. Do this gradually, alternating from one
nut to the other until both are tight
8. Connect the water inlet hose on the back of the panel to the water supply.
9. Turn on the water supply to make sure there are no leaks in the water feed tube(s). If leakage does occur, use your
adjustable wrench to tighten the connections as necessary. If problems persist, contact Customer Service at
1-866-855-2284. If no leaks are detected, turn on the shower panel and check to make sure that all connections are.
Divert the water to the each output and allow the water to ow for approximately 60 seconds.
CARE AND MAINTENANCE
To maintain the natural wood nish, install and store the shower panel in a dry, well ventilated space. Do not clean the
shower or shower tray with any acidic soaps or detergents. After use, rinse with clean water and wipe dry to remove any
dirt or soap residue as this may damage the bamboo over time. To protect the nish and extend the lifetime of your outdoor
shower, remove hard-soled shoes prior to stepping onto the shower tray.
Adjustable Wrench