Installation Sheet

2Single Hole Faucet Installation Instructions
8. Hand tighten to attach the water feed tubes to the main water supply, being careful not to cross the two during
installation. Give a ¼ turn with pliers or wrench, but don’t over tighten. Curve tubes as necessary to ensure there are no
kinks or knots.
9. When your faucet installation is complete, turn on the water supply. Check to make sure that all connections are tight
(no water should be leaking) and that the hot and cold supplies are working correctly. Turn the water on and allow the
water to ow through the spout for approximately 60 seconds. Divert the water to the spray hose and allow the water to
ow through the hose for approximately 60 seconds.