Installation Sheet

1Spinoza Single-Hole Faucet Installation Instructions
Ø35
SPINOZA SINGLE-HOLE FAUCET
INSTALLATION INSTRUCTIONS
Before installing, read entire Single Hole Faucet Installation Instructions. Observe all local building and safety codes.
Unpack and inspect the product for any shipping damages. If you nd damages, do not install. Contact Customer Service
at 1-866-855-2284. If you need assistance or have questions while installing your Single Hole Faucet, contact Customer
Service.
We recommend consulting a professional if you are unfamiliar with installing kitchen xtures. Signature Hardware
accepts no liability for any damage to the oor, walls, plumbing or for personal injury during installation.
TOOLS AND MATERIALS:
INSTALLATION
1. Attach the exible water feed tubes to the tail-piece.
2. Thread the faucet through the mounting hole and thread the mounting hardware onto the tail-piece from underneath
the sink.
3. Make sure that faucet is properly aligned and tighten the screws on the mounting nut with a screwdriver.
4. Hand tighten to attach the water feed tubes to the main water supply, being careful not to cross the two during
installation. Curve tubes as necessary to ensure there are no kinks or knots.
5. When your faucet installation is complete, turn on the water supply. Check to make sure that all connections are tight
(no water should be leaking) and that the hot and cold supplies are working correctly. Turn the water on and allow the
water to ow through the spout for approximately 60 seconds.
Screwdriver