Installation Sheet

1Console Sink Installation Instructions
Read entire Console Sink Installation Instructions.
Observe all local building and safety codes.
TOOLS AND MATERIALS:
Pencil
BEFORE INSTALLING INSTALLATION
CONSOLE SINK
1. Hold the sink, with the porcelian legs in place, in the
installation location and mark the wall through the mounting
holes on the back of the sink.
Important: The sink should be anchored to two wall studs. Locate and mark
the position of the wall studs to which you will fasten your sink by listening for
a solid sound as you knock on the wall or by using a stud finder. If the studs
in your bathroom do not line up to the mounting location for your sink, wood
blocking can be installed between the studs using standard 2 x 4’s. If wood
blocking needs to be installed behind the finished wall, we recommend
consulting a professional if you are unfamiliar with this type of installation.
2. Drill mounting holes for the anchor or lag bolts using the
guides created in the previous step. If the wall is tile, use a
masonry drill bit.
3. Secure the sink to the wall with the mounting hardware. After
inserting the first fastener, verify that the sink is level. When the
sink is properly aligned insert the remaining fasteners.
4. Run a bead of silicone adhesive along the top and bottom of
each porcelain leg. Slide the legs in place beneath the sink.
5. Use a level to verify that each leg is perfectly straight.
6. Wipe away any excess silicone with a soft cloth.
7. Let silicone sealant dry for 24 hours before using your console
sink. If a lavatory drain is included, move on to the Drain Installation
section.
Level
Drill
Silicone
Adhesive
INSTRUCTIONS
Unpack and inspect the product for any
shipping damages. If you find damages, do not
install. Contact Customer Service at
1-866-855-2284. If you need assistance or
have questions while installing your sink,
contact Customer Service.
Because wall construction and materials vary
from home to home, Signature Hardware does
not provide mounting hardware for all of our
console sinks. The appropriate mounting
hardware can be purchased from your local
hardware store. For this installation it is
assumed that any old fixtures have been
removed and all rough-in work has been
completed.
We recommend consulting a professional if
you are unfamiliar with installing bathroom
fixtures. Signature Hardware accepts no
liability for any damage to the floor, walls,
plumbing or for personal injury during
installation.
Soft Cloth
Stud Finder
Tape Measure
Wall
Studs