Installation Sheet

4
RESIN TUB WITH INTEGRAL DRAIN
INSTALLATION INSTRUCTIONS
1. Set the tub in the desired location and mark the
drain hole location on the floor. Then, move the tub
away from the desired installation location so that the
plumbing can be installed.
2. Turn bathtub upside down and rest it on a moving
blanket, cardboard, or other soft surface to prevent
scratching the rim. Use caution when turning the
bathtub upside down, as the product may be heavy
and may require assistance to rotate.
INSTALLATION:
WITHOUT UNDERFLOOR ACCESS /
SLAB FLOOR INSTALLATION
Moving blanket
TOP
BOTTOM
3. Place a level across the bottom of the tub to
represent floor level. Raise adjustable leveling
supports to touch level. Then, raise the support an
additional 1/8" to ensure the bathtub is supported by
the support feet and not by the tub walls.
4. Once support feet are adjusted, dry fit the PVC
hub adapter onto the drain threads. Use a tape
measure to determine the gap between the bottom
of the tub, starting at the drain inside flange of the
hub adapter, and the floor. Use the level to simulate
the floor. The drain pipe should extend approximate-
ly 1” above the finished floor; however, this will vary
depending on the height of the tub.
Tape measure
1/8”
Support feet
Tub wall
PVC hub adapter