Installation Sheet

INSTALLATION

1. Ensure that the main water supply is shut oﬀ before

you begin.

PONCIA SINGLE HOLE FAUCET

GETTING STARTED

TOOLS AND MATERIALS:

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

faucet, plumbing, sink, counter top, or personal injury

during installation.

Observe all local plumbing and building codes.

Unpack and inspect the item for damage.

If any damage is found, contact our

Customer Relations team at 1-866-855-2284.

Ensure that you have gathered all of the required

materials that are needed for the installation.

For these instructions, it is assumed that the old

faucet has been completely removed and any

necessary repairs or modiﬁcations to the water

supply have been completed.

Plumber’s Tape*

Thread Sealant*

Adjustable

Wrench*

Hex Wrench

1Poncia Pot Filler Installation Instructions

Phillips

Screwdriver*

Pencil

2. A ½” pipe nipple will need to be installed into the wall

to connect the pot ﬁller. The nipple will need to protrude

no more than ½” from the ﬁnished wall.

OFF

1/2”

PAGE 1
PONCIA SINGLE HOLE FAUCET BEFORE YOU BEGIN INSTALLATION We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or personal injury during installation. 1. Ensure that the main water supply is shut oﬀ before you begin. Observe all local plumbing and building codes. Unpack and inspect the item for damage.
PAGE 2
PONCIA SINGLE HOLE FAUCET 3. Temporarily attach the water supply bracket to the ½” pipe nipple until hand tight. Once tight against the wall, use a pencil to mark the location of the three mounting holes on the wall. 4. Remove the water supply bracket and drill pilot holes into the wall at the three marked mounting hole locations. Insert the provided anchors into the drilled holes. 5. Reattach the water supply bracket by threading it onto the ½” pipe nipple.
PAGE 3
PONCIA SINGLE HOLE FAUCET 7. Attach the pot ﬁller by pushing it onto the mounted water supply bracket. Secure it to the wall by tightening the set screw on the bottom of the base. Slide the decorative escutcheon against the wall to disguise the bracket. 9. Remove the aerator from the spout using the provided removal tool. Turn the pot ﬁller on and allow the water to ﬂow for approximately 60 seconds to remove any dust or loose sediment from the water line. Check for any leaks.