Installation Sheet

COOPER TUB SPOUT INSTALLATION

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

plumbing, ﬂoor, walls, tub, or for personal injury during

installation.

Observe all local plumbing and building codes.

Unpack and inspect the item for shipping damage. If any

damage is found, contact our Customer Relations team

at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

For the following installation instructions, it is

assumed that the ﬁnished wall has been completed

and a valve is already installed.

Before you begin, the main water supply to your home

should be shut oﬀ.

TOOLS AND MATERIALS:

Plumbers

Tape

Adjustable

Wrench

1Cooper Tub Spout Installation Instructions

Tape Measure

Hex Wrench

SKU(s): 940970

PAGE 1
SKU(s): 940970 COOPER TUB SPOUT INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the plumbing, ﬂoor, walls, tub, or for personal injury during installation. TOOLS AND MATERIALS: Plumbers Tape Tape Measure Hex Wrench Observe all local plumbing and building codes. Unpack and inspect the item for shipping damage.
PAGE 2
COOPER TUB SPOUT INSTALLATION INSTALLATION 1. To prepare for installation, a female inlet should be installed at the desired installation location. 3. Remove the two screws located on the back of the tub spout, as shown. screws female inlet 2. Loosen the set screw on the bottom of the spout and remove the nipple from the back of the tub spout, as shown. 4. Secure the backplate to the back of the tub spout using the screws that were removed in step 3. Tighten ﬁrmly.
PAGE 3
COOPER TUB SPOUT INSTALLATION 5. Apply plumber’s tape or thread sealant to the threads of the nipple. Screw the nipple into the prepared female inlet. Tighten ﬁrmly using an adjustable wrench. 7. Once the spout is in place and properly aligned, secure the spout by tightening the set screw underneath, as shown. plumber’s tape female inlet 6. Connect the tub spout to the installed nipple. Push ﬁrmly into place. Ensure that the spout is aligned straight. 8.