Installation Sheet

DROP-IN/UNDERMOUNT FIRECLAY SINK

INSTALLATION

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing this type of product. Signature

Hardware accepts no liability for any damage to the

faucet, plumbing, sink, counter top, or for personal injury

during installation.

Observe all local plumbing and building codes.

Unpack and inspect the product for shipping damage. If

any damage is found, contact our Customer Relations

team at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

For these instructions, it is assumed that the old sink

has been removed, and the area is prepared for new

sink installation.

TOOLS AND MATERIALS:

1Drop-In/Undermount Fireclay Sink Installation Instructions

Pencil

Tape Measure

Safety Glasses

Silicone Sealant

(100% Neutral

Cure)

Cloth

Phillips

Screwdriver

Level

PAGE 1
DROP-IN/UNDERMOUNT FIRECLAY SINK INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing this type of product. Signature Hardware accepts no liability for any damage to the faucet, plumbing, sink, counter top, or for personal injury during installation. TOOLS AND MATERIALS: Phillips Screwdriver Tape Measure Cloth Observe all local plumbing and building codes. Unpack and inspect the product for shipping damage.
PAGE 2
DROP-IN/UNDERMOUNT FIRECLAY SINK INSTALLATION DROP-IN INSTALLATION 1. Test-ﬁt the sink by lowering it into the prepared cutout in the counter. The perimeter of the sink rim should sit ﬂush on the counter. Remove the sink. 3. Carefully lower the sink back into its prepared cutout. Press ﬁrmly into place. Ensure that the sink is level and properly aligned. Wipe away any excess silicone around the rim of the sink with a damp cloth. 2.
PAGE 3
DROP-IN/UNDERMOUNT FIRECLAY SINK INSTALLATION UNDERMOUNT INSTALLATION 1. Construct a wooden frame to support the sink. Measure your sink to determine the dimensions. 3. Set the sink into the wood framing that was contructed in step 1. Press ﬁrmly into place. 2. Turn the sink over and apply a generous bead of silicone sealant along the bottom of the sink rim. 4. Apply a generous bead of silicone along the top of the sink rim, then proceed to installing the countertop.