Installation Sheet

ManualsBrandsSignature Hardware ManualsHardwareLampton Solid Brass Cremone Bolt for 6' Windows

1Cremone Bolt Installation Instructions

INSTRUCTIONS

Unpack and inspect the product for any

shipping damages. If you ﬁnd damages, do not

install. Contact Customer Service at

1.866.855.2284. If you need assistance or

have questions while installing your cremone

bolt contact Customer Service.

We recommend consulting a professional if

you are unfamiliar with installing hardware

ﬁxtures. Signature Hardware accepts no

liability for any damage to the bolt or door, or

for personal injury during installation.

Read the installation instructions below. Observe all

local building and safety codes.

TOOLS AND MATERIALS:

BEFORE INSTALLING FLUSH-MOUNT INSTALLATION

1. Turn the cremone bolt handle (A) until the cremone mechanism

is fully extended.

2. Assemble the cremone bolt by hooking the rods onto the

cremone mechanism.

3. Hold the bolt together and place it in the desired mounting

location on the face of your door or window.

Note: The flat side of the rods should be against the installation surface.

4. Mark the locations of the mounting holes in the bolt handle.

5. Determine the appropriate bolt rod length. The rods should

extend 1/2" past the edge of the door. Trim the rods with a

hacksaw as necessary.

6. Set the bolt aside and drill mounting holes in the locations

marked in step 4.

7. Attach the bolt assembly (handle, and rods) to the installation

surface with the ﬂat face of the rods against the surface.

8. Holding the rods in place, attach the upper and lower mid-point

guides (B) to the installation surface. Use a level to

make sure that the rods are properly aligned. At this point, the bolt

assembly is self-supported.

9. Attach the upper and lower end guides (C), allowing enough

room for the end socket strikes.

10. Attach the end socket strikes (D) to the face of the trim above

and below the door or window.

Refer to Figure 1 on page 2.

CREMONE BOLT

Level

Drill

Hacksaw

Marker

Chisel

Summary of content (2 pages)

PAGE 1
CREMONE BOLT BEFORE INSTALLING FLUSH-MOUNT INSTALLATION Read the installation instructions below. Observe all local building and safety codes. 1. Turn the cremone bolt handle (A) until the cremone mechanism is fully extended. 2. Assemble the cremone bolt by hooking the rods onto the cremone mechanism. INSTRUCTIONS Unpack and inspect the product for any shipping damages. If you ﬁnd damages, do not install. Contact Customer Service at 1.866.855.2284.
PAGE 2
RECESSED INSTALLATION 7. Attach the bolt assembly (handle, and rods) to the installation surface with the ﬂat face of the rods against the surface. 1. Turn the cremone bolt handle (A) until the cremone mechanism is fully extended. 2. Assemble the cremone bolt by hooking the rods onto the cremone mechanism. 3. Hold the bolt together and place it in the desired mounting location on the face of your door or window. 8.