Installation Sheet

ManualsBrandsSignature Hardware ManualsPlumbingCooper Pressure Balanced Shower System with 10" Rain Shower Head and Hand Shower - Rough In Included

COOPER PUSH-BUTTON SHOWER VALVE

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are



Hardware accepts no liability for any damage to the









damage is found, contact our Customer Relations team



Ensure that you have gathered all the required



For the following installation instructions, it is

assumed that the wall has been opened and that the



Before you begin, the main water supply to your home



TOOLS AND MATERIALS:

Plumbers

Tape



Wrench

Phillips

Screwdriver

1

Tape Measure

Drill



Wood Blocking

Soldering Kit

(for copper pipe)

½" Test Plug

Level

Pencil or

Marker

Hacksaw

SKU(s): 940964

Summary of content (4 pages)

PAGE 1
SKU(s): 940964 COOPER PUSH-BUTTON SHOWER VALVE BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing �xtures. Signature Hardware accepts no liability for any damage to the plumbing, �oor, walls, tub, or for personal injury during installation. TOOLS AND MATERIALS: Plumbers Tape Tape Measure Adjustable Wrench Drill Observe all local plumbing and building codes. Unpack and inspect the item for shipping damage.
PAGE 2
COOPER PUSH-BUTTON SHOWER VALVE INSTALLATION 1. To prepare for installation, wood blocking should be installed between the two studs where the valve will mount. Be careful not to set the valve too far back into the wall. Use the sticker on the side of the valve for guidance. 3. Hold the valve at it’s installation location, and mark the location of the mounting holes with a pencil. Use a level to ensure that the valve is straight before marking.
PAGE 3
COOPER PUSH-BUTTON SHOWER VALVE 5. Secure the valve to the prepared wood blocking using the provided hardware. Ensure that the hot outlet is pointing to the left, and the cold outlet is pointing to the right. Tip: Leave the protective sleeves on the valve stems until your �nished wall is complete, and you are ready to install the trim pieces. 6. Route, assemble, and connect all in-wall piping to and from the shower valve. Make connections appropriately depending upon the type of pipe that is being used.
PAGE 4
COOPER PUSH-BUTTON SHOWER VALVE 7. Once all piping is routed and connections have been made, use a ½” test plug to perform a water pressure test. Turn on the main water supply to your home and water test the installed plumbing. Ensure that there are no leaks, then shut the water o�. Remove the test plug, and slide the protective sleeves back onto the valve. 8. Once the �nished wall is complete, use a hacksaw to cut the protective plastic cover from the valve, as shown.