Installation Sheet

EUBANKS BIDET TOILET SEAT INSTALLATION

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

product, plumbing, toilet, wall, ﬂoor, or for personal injury

during installation.

Observe all local plumbing and building codes.

Unpack and inspect the items for shipping damage. If

any damage is found, contact our Customer Relations

team at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

For these instructions, it is assumed that the old toilet

seat has been completely removed and any neces-

sary repairs or modiﬁcations have been completed.

TOOLS AND MATERIALS:

Plumbers

Tape

Thread

Sealant

1Eubanks Bidet Toilet Seat Installation Instructions

Adjustable

Wrench

Phillips

Screwdriver

PAGE 1
EUBANKS BIDET TOILET SEAT INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the product, plumbing, toilet, wall, ﬂoor, or for personal injury during installation. TOOLS AND MATERIALS: Plumbers Tape Thread Sealant Adjustable Wrench Observe all local plumbing and building codes. Unpack and inspect the items for shipping damage.
PAGE 2
EUBANKS BIDET TOILET SEAT INSTALLATION INSTALLATION Mounting Bracket Installation (Fig.1): Bolt 1. Insert the rubber anchors into the toilet’s seat mounting holes. Metal washer 2. Place the mounting bracket over the mounting holes, Mounting bracket Clamps Rubber anchor 3. Secure the mounting bracket to the toilet using the provided clamps, rubber washers, and screws, as shown. Tighten using a screwdriver. Seat Installation (Fig. 2): Mounting bracket 1. Place the seat onto the toilet bowl.
PAGE 3
EUBANKS BIDET TOILET SEAT INSTALLATION OPERATING INSTRUCTIONS Rear cleaning Feminine cleaning Rotary button CLEANING AND MAINTENENCE Inlet Filter Cleaning: 1. Before you begin, shut oﬀ the toilet’s main water supply valve. 2. Disconnect the water hose connected to the toilet seat’s inlet. 3. Remove the ﬁlter using needle nose pliers, as shown. Clean by rinsing under warm water. Use a brush if needed. 4. Reinsert the ﬁlter, and reattach the hose. Turn the water supply back on.