Installation Sheet

11. If you purchased a bidet seat, connect the

three-way valve and hose to the inlet of the toilet seat.

Then, using a second hose, connect the opposite end

of the three-way valve to the toilet’s main shutoﬀ valve

on the wall, as shown.

Note: Apply plumber’s tape or thread sealant to

each threaded connection.

12. If you did not purchase a bidet seat, connect the

water supply tubes at the bottom of the tank. Turn on

the water supply and ﬂush the toilet several times to

check for any leaks around the back or base.

9. Thread washers and nuts onto the tank bolts. Verify

that the tank is level and alternately tighten the

washers and nuts until the tank is resting ﬁrmly on the

bowl.

10. Attach the toilet seat.

TOILET

INSTALLATION INSTRUCTIONS

Hose

Water ﬁlling hole

Three-way valve

Angle valve