Installation Sheet

EDISON POT FILLER INSTALLATION

GETTING STARTED

BEFORE YOU BEGIN

We recommend consulting a professional if you are

unfamiliar with installing plumbing ﬁxtures. Signature

Hardware accepts no liability for any damage to the

faucet, plumbing, counter top, or for personal injury

during installation.

Observe all local plumbing and building codes.

Unpack and inspect the faucet for shipping damage. If

any damage is found, contact our Customer Relations

team at 1-866-855-2284.

Ensure that you have gathered all the required

materials that are needed for the installation.

For these instructions, it is assumed that any old

faucet has been completely removed and any

necessary repairs or modiﬁcations to the water

supply have been completed.

TOOLS AND MATERIALS:

Plumbers

Tape

Thread

Sealant

Adjustable

Wrench

Small

Bucket

Basin

Wrench

1Edison Pot Filler Installation Instructions

SKU(s): 941717

PAGE 1
SKU(s): 941717 EDISON POT FILLER INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing plumbing ﬁxtures. Signature Hardware accepts no liability for any damage to the faucet, plumbing, counter top, or for personal injury during installation. TOOLS AND MATERIALS: Plumbers Tape Thread Sealant Basin Wrench Observe all local plumbing and building codes. Unpack and inspect the faucet for shipping damage.
PAGE 2
EDISON POT FILLER INSTALLATION INSTALLATION 1. Ensure that the water supply below your sink is completely shut oﬀ by turning the shutoﬀ valves all the way to the right. 3. From beneath the sink, slide the rubber washer and metal washer back onto the shank. Thread the lock nut until hand tight. Finish tightening using a basin wrench. Tip: Place a small bucket below your workspace to catch any water that may drip during the installation process. OFF 2.
PAGE 3
EDISON POT FILLER INSTALLATION 5. Once installation is complete, turn the main water supply back on. Check for any leaks underneath. 6. Once installation is completed, remove the aerator from the spout and turn the pot ﬁller on for approximately 60 seconds to remove any dust or loose sediment from the water line. Ensure that there are no leaks. Turn the water oﬀ and reattach the aerator.