Installation Sheet

ManualsBrandsSignature Hardware ManualsShop All Signature HardwareSignature Hardware Teague 32" Single Vanity Set with Plywood Cabinet and Ceramic Vanity Top with Rectangular Integrated Ceramic Sink - Single Faucet Hole

1Trough Sink Vanity Installation Instructions

TROUGH SINK VANITY INSTALLATION

GETTING STARTED

TOOLS AND MATERIALS:

BEFORE YOU BEGIN

We recommend consulting a professional if

you are unfamiliar with installing bathroom

ﬁxtures and plumbing. Signature Hardware

accepts no liability for any damage to the

ﬂoor, walls, plumbing, vanity, cabinet, sink, or

personal injury during installation.

Observe all local plumbing and building

codes.

Unpack and inspect the vanity for damage.

If any damage is found, contact our

Customer Relations team at

1-866-855-2284.

*not included

Ensure that you have gathered all of the

required materials that are needed for

the installation.

Ensure that your bathroom ﬂoor is

adequately supported, and the ﬁnished

ﬂoor is level.

Ensure that there is adequate support

behind the bathroom wall before

installation.

PLANNING

Use the vanity’s PDF speciﬁcation sheet as

a reference when planning your layout. The

speciﬁcation sheet can be found and

downloaded from the product page on our

website.

Because the vanity’s speciﬁcation

measurements are approximate and slight

variations may occur, we highly recommend

performing any rough-in procedures with

the vanity on site.

Pencil*

Tape Measure*

Stud Finder*

Neutral Cure

Silicone Sealant*

Damp Cloth*

Level*

Screwdriver*

Wood Shims*

Drill*

NEVER LIFT THE VANITY TOP FLAT NEVER CARRY THE VANITY TOP FLAT

Summary of content (3 pages)

PAGE 1
TROUGH SINK VANITY INSTALLATION BEFORE YOU BEGIN We recommend consulting a professional if you are unfamiliar with installing bathroom ﬁxtures and plumbing. Signature Hardware accepts no liability for any damage to the ﬂoor, walls, plumbing, vanity, cabinet, sink, or personal injury during installation. Observe all local plumbing and building codes. Unpack and inspect the vanity for damage. If any damage is found, contact our Customer Relations team at 1-866-855-2284.
PAGE 2
TROUGH SINK VANITY INSTALLATION INSTALLATION STEP 1: CABINET INSTALLATION 1. Determine the location where you would like to install your vanity. 2. Locate and mark the location of the studs to which you will fasten your vanity. You can locate studs by using a stud ﬁnder. Important: If the studs in your bathroom do not line up to the mounting location for your vanity, wood blocking can be installed between the studs using standard 2 x 4’s.
PAGE 3
TROUGH SINK VANITY INSTALLATION STEP 2: SINK INSTALLATION 1. Apply a bead of silicone sealant around the top edge of the vanity cabinet. 3. Let the assembled vanity sit for 24 hours to allow all the silicone sealant to fully dry. Once dry, proceed to the installation of your faucet and drain. Note: In some situations, it may be necessary to cut the inner cabinet shelf to allow space for your drain’s P-trap. 24 hr 2.