Installation Sheet

3Vanity Installation Guide
SINK INSTALLATION
UNDERMOUNT SINK INSTALLATION
1. Carefully turn the counter top over, resting it on a soft, stable surface to prevent damage.
2. Position the undermount sink over the sink cutout on the counter top. Make sure the sink is centered with the faucet
hole and is evenly spaced between the bolt holes.
3. Draw an outline of the sink on the counter top.
4. Remove the sink from the counter top. Apply a generous bead of silicone sealant around the perimeter of the sink
rim.
5. Carefully place the sink upside down on the counter top, positioning it within the outline.
6. At each of the bolt holes in the counter, attach sink clips by placing the long end of the bracket at against the sink
lip. Screw the wing bolts through the brackets and bolt holes and tighten snugly.
7. Carefully turn the counter top and sink over. If needed, reposition the sink by slightly loosening the wing bolts and
adjusting.
8. Remove any excess sealant and let dry for 24 hours.
SEMI-RECESSED SINK INSTALLATION
1. Carefully turn the sink over to rest upside down on the counter top.
2. Apply a continuous bead of silicone sealant to the outer edge of the sink where it will contact the counter.
3. Turn the sink back over, placing it inside the 13" cutout and position until centered.
4. Remove any excess sealant and let dry for 24 hours.