Installation Sheet

3
11. Allow the sealant to cure before proceeding.
11. Permita que el sellador se seque antes de continuar.
8. Clean the underside of the countertop, ensuring
the surface is smooth and free of defects.
8. Limpie la parte inferior de la encimera, asegurándose
de que la superficie esté suave y libre de defectos.
7. Place the mounting clip anchors into the pre-drilled
countertop holes. If necessary gently tap to insert.
7. Coloque los anclajes de montaje en los orificios de la
encimera perforados previamente. Si es necesario,
presione ligeramente para insertar.
9. Apply a bead of silicone sealant along the edge of
the underside of the countertop. Position and align
sink within opening. Press sink into silicone seal. Wipe
off any excess sealant immediately.
9. Aplique una línea de sellador de silicona alrededor del
borde de la parte inferior de la encimera. Coloque y
alínee el fregadero con el hueco. Presione el fregadero
contra el sellador de silicona. Limpie cualquier exceso de
sellador inmediatamente.
10. Install the mounting clips and tighten until the sink
rim is aligned to the countertop. Ensure that the front
of the sink is parallel to the countertop. Adjust and
retighten if needed. Do not overtighten.
10. Instale los anclajes de montaje y ajuste hasta que el
borde del fregadero esté alineado con la encimera.
Asegúrese de que la parte frontal del fregadero esté
paralela a la encimera. Ajuste y vuelva a ajustar si es
necesario. No ajuste demasiado.
12. Connect faucet supply lines and drain assembly
according to manufacturer’s instructions.
12. Conecte las tuberías de suministro y de drenaje al
grifo siguiendo las instrucciones del fabricante.
1.800.221.33791.800.221.3379
mounting clip anchor
el anclaje de montaje
mounting clip anchor
anclaje de montaje
mounting clip
gancho de instalación
screw
tornillo
sink
fregadero
countertop
encimera
STAINLESS STEEL UNDERMOUNT SINK
FREGADERO DE MONTAJE BAJO ENCIMERA
SKU: 948567, 948490, 948491, 948453, 948454, 948492, 948493, 948495, 948494, 948453