Installation Sheet

3
6. The overflow tee (A) will be attached at the points
where the drain pipes intersect (B).
7. Measure and mark each pipe so that the end of the
pipe reaches at least a little bit over halfway into the
overflow tee.
8. Remove the drain and overflow assembly from the tub,
and trim the pipes at the marked locations with a hacksaw.
Make sure that the blade is suitable for cutting metal
9. Apply thread sealant or plumber’s tape to the
threaded ends of all pipes prior to assembly. If two pipes
arrive attached, be sure to take them apart and do the
same. Do not apply any tape or sealant to any
compression fittings. Follow steps 10-13 for drain
assembly instructions.
10. Apply 100% neutral cure silicone sealant to the
underside of the drain flange and thread it through the
tub and into the drain pipe. Apply thread sealant or
plumber’s tape to the threaded connection to ensure a
water-tight seal. Tighten by hand. Wipe away any excess
sealant using a damp cloth.
CAST IRON PEDESTAL TUB
Cast Iron Pedestal Tub Installation Instructions
A
B