Installation Sheet

ManualsBrandsSignature Hardware ManualsPlumbingScarlett 72" Cast Iron Soaking Pedestal Freestanding Tub with Integrated Drain and Overflow, 7" Rim Holes and Tap Deck

1Cast Iron Tub Installation and Care Guide

CONTENTS

Tub Installation.............................................................................2

Rough-In.....................................................................................2

Drain Installation...........................................................................3

Drain without Overow................................................................3

Waste and Overow Drain..........................................................3

Trimming Drain Pipes..............................................................4

Maintenance and Care.................................................................5

CAST IRON FREESTANDING TUB

INSTALLATION INSTRUCTIONS AND CARE GUIDE

Summary of content (5 pages)

PAGE 1
CAST IRON FREESTANDING TUB INSTALLATION INSTRUCTIONS AND CARE GUIDE CONTENTS Tub Installation.............................................................................2 Rough-In.....................................................................................2 Drain Installation...........................................................................3 Drain without Overflow................................................................3 Waste and Overflow Drain.....................................
PAGE 2
TUB INSTALLATION Before you begin, read the following installation and care instructions. Observe all local plumbing, building, and electrical codes. Install your tub on an adequately supported and level finished floor. Unpack and inspect your tub for damages. If any damage is found, contact Customer Service at 1-866-855-2284 and return the tub to the packing crate. If you need assistance while installing your new tub, call Customer Service.
PAGE 3
DRAIN INSTALLATION DRAIN INSTALLATION (NO OVERFLOW) 1. Set the tub in the desired installation location and mark the drain hole location on the floor. If your tub is not present, mark the location determined in the Rough-In section. 2. Move the tub away from the installation location so that the plumbing can be installed. The drain pipe should extend approximately 6” above the finished floor. 3.
PAGE 4
5. Apply thread sealant or plumber’s tape to the threads at each end of all pipes prior to installation. If two pipes arrive attached, be sure to take them apart and apply sealant before installing. C Press and Seal Swivel Drain 6. Connect the tub shoe assembly (A) and rubber washer to the tub drain (B). 7. Install the overflow assembly (C) with the beveled washer, overflow plate, mounting screw (provided) and any other washers or rubber sealing gaskets included. Press and Seal Swivel Drain 8.
PAGE 5
MAINTENANCE AND CARE Porcelain enamel is a hard, glass-like surface that is not easily scratched and is extremely durable. Cast iron tubs have a porcelain enamel surface that is fused to the cast iron under high temperatures and is one of the best heat resistant coatings available. Over time, if the incorrect cleaners are used, small pits or scratches may occur that can trap dirt in the porcelain. A thorough rinsing and wipe-down with a soft cloth is recommended after each use.