Installation Sheet

4Copper Freestanding Tub Installation Instructions
COPPER FREESTANDING TUB
TUB AND DRAIN WITH OVERFLOW
1. Set the tub in the desired installation location and
drop a plumb line from the center of the overflow
hole to the floor. This will determine your drain
location. Mark the drain hole location on the floor.
2. Move the tub away from the installation location so
that the plumbing can be installed. Place the drain pipe
at the appropriate height for waste and overflow piping.
To determine this, you will need to temporarily fit your
drain pipe into the tub and measure from the floor to
the center of the drain pipe.
3. Carefully set the tub in position. If the tub has
leveling feet, adjust as necessary until level and apply a
generous amount of silicone under each foot. If your
tub does not have leveling feet, shims can be used for
leveling if your floor is not flat.
4. Next you will need to trim your drain and overflow
pipes to the appropriate sizes. Steps 5-8 will walk you
through.
5. To trim the drain annd overflow pipes appropriately,
you will need to temporarily install the overflow and
drain assemblies into the tub.