Installation Sheet

STAINLESS STEEL TUB INSTALLATION
INSTALLATION
3. When the floor is finished, measure and cut the
drain pipe to the appropriate length for the type of
drain that is being used.
4. Carefully set the tub in position. If the tub has
leveling feet, adjust as necessary until level and apply a
generous bead of silicone under each foot. If your tub
does not have leveling feet, shims can be used for
leveling if your floor is not flat.
1. Set the tub in the desired installation location and
mark the drain hole location on the floor,
2. Move the tub away from the installation location so
that plumbing can be installed. The drain pipe should
extend approximately 6" above the finished floor.
2Stainless Steel Tub Installation Instructions
Proceed to the appropriate drain configuration
to complete rough-in and installation.
TUB AND DRAIN WITHOUT OVERFLOW
6 inches