Installation Sheet

4. Next you will need to trim your drain and overflow pipes
to the appropriate sizes. Steps 5-8 will walk you through.
ACRYLIC FREESTANDING TUB
4 Acrylic Freestanding Tub Installation
3. Carefully set the tub back into position and adjust the
tub feet as necessary until level. Once level, apply a
generous bead of silicone on the bottom of the feet.
This will prevent the tub from shifting after installation.
Tip: Plan for the bottom of the tub to sit approximately
1/8" above the finished floor so that the weight of the
tub, water, and bather are fully supported by the tub feet
rather than the tub walls.
5. To trim the drain and overflow pipes appropriately, you
will need to temporarily fit the overflow and drain
assemblies to the tub.
6. The overflow tee (A) will be attached at the points
where the drain pipes intersect (B).
7. Measure and mark each pipe so that the end of
the pipe reaches at least a little bit over halfway into
the overflow tee.
A
B