Installation Sheet

2
1.800.221.3379
INSTALLATION
INSTALACIÓN
1. The stub out 5/8” pipe should extend a minimum of
2” from the wall, but not to exceed 3” from the wall.
Remove all burs and sharp edges from the stub out
5/8” pipe. Sharp edges or burs can cut or damage the
o-rings inside of the tub spout.
1. El extremo sobresaliente de la tubería de 5/8 plg debe
extenderse 5.08cm como mínimo desde la pared, pero
sin pasar de 7.62 cm. Elimina todas las rebabas y bordes
filosos del extremo sobresaliente de la tubería de 5/8
plg. Sharp edges or burs can cut or damage the o-rings
inside of the tub spout.
2. Place spout onto quick connection until the spout
becomes flush with the finished wall and tighten screw
(1) with phillips head screwdriver.
Note: The distance from the valve to the tub spout
stub out should be between 8” (203.2mm) and 18”
(457.2mm).
2. Coloca la canilla en el conector rápido hasta dejarla al
ras con la pared terminada y apretar entonces el tornillo
(1) con el desarmador de cabeza Phillips.
Nota: La distancia desde la válvula hasta el caño
sobresaliente de la bañera debe ser de 8” a 18” (20.3 cm
a 45.7 cm).
MODERN
TUB SPOUT
CAÑO DE LA TINA
SKU: 949097
wall
pared
2" [50.8mm] MIN
3" [76.2mm] MAX
1
8" [203.2mm] min
18" [457.2mm] max
5/8" (16mm)