Installation guide
Page 23
Maintenance (Continued)
Replacing J4 Type Halogen Light Bulb:
This range hood uses halogen light bulb: 20W 12V (Product ID: SV-ACS-HAL20W-B).•
Make sure the range hood is unplugged or turn OFF breaker and the lights are cool to touch.•
Place a small at-head screwdriver between light housing and lens cover, carefully and gently pry up the lens cover.•
Remove the old halogen light bulb by pulling in the direction of wavy arrow. Do not touch the new light bulb with •
bare hands.
Reverse the steps to install a new halogen light bulb. Turn ON breaker and range hood to test for operation.•
Replacing MR16 / GU10 Type Halogen Light Bulb:
This range hood uses halogen bulb (please refer to the actual specication of the hood purchased):•
USA/Canada:
35W Type MR16 12V / Type GU10 120V
Europe and other Countries:
35W Type MR16 12V / Type GU10 220V
Make sure the range hood is unplugged or turn OFF breaker. •
Make sure the lights are cool to touch, carefully align the arrow on the inner ring with the arrow on the outer ring where •
it says OPEN. The inner ring will loosen and the light bulb will be available for removal. Install a new halogen light
bulb and reverse the steps.
Turn ON breaker and range hood to test for operation.•
Light Housing
Flat-head
Screwdriver
Lens Cover
Lens Cover
Halogen Bulb
Lens Cover
Align arrows on both rings
WARNING
Hazard of Burns!
Light bulb become extremely hot when turned on.
DO NOT touch bulb until switched off and cooled.
Touching hot bulbs could cause serious burns.