ASSEMBLY INSTRUCTIONS Style# R1220 Console Table NOTE TO CUSTOMERS: For ease and speed of assembly we recommend that before you commence each step of the assembly that you identify all the parts required to complete that step. ‘We recommend that where possible you allow sufficient space to assemble the item as close as possible to the place where it will be once assembled.
To insert a cam lock: (Please read below instructions before assembling) Diagram Insert cam screw into hole as shown in diagram A . = Diagram B Make sure not to insert the cam screw: Too deep as shown in figure B as this will cause the a HRW cam screw to be misaligned and unable to Wl interlock properly. Diagram C fa . Also avoid inserting the cam screw too close to the surface of the hole as shown in figure C, as this will [aC £9 @B cause the cam lock to be too loose, and not interlock al properly. H 2.
Part List Al Quantity |A2 (L&R) Quantity | A3 Quantity | A4 Quantity Top Panel Side Panel Boston Panel Leg AS Quantity 46 Quantity | A7 Quantity | Ag Quantity Shelf Door (L&R) Cross Bar Back Panel .
STEP 1 B1 e= PCs B8 4% 0 sets Assemble Legs A4 to Bottom Panel A3 using Wood Dowels B1 and Bolts B8 with washers. STEP 2 B1 poss B2 «——e @sets Assemble Side Panel to Shelf AS using Cam Locks B2 and Wood Dowels (B1).
STEP 3 B1 z= PCs B2 ace @ sets Assemble Side Panels to Bottom Panel A4 using Wood Dowels B1 and Cam Locks B2. STEP 4 B3 ee PCs BS ee PCs Assemble Cross Bar A7 to the bottom of Top Panel Al using Wood Dowels B9 and Screws B3.
STEP 5 B4 ~~ PCs B6 %, PCs Assemble Magnet B4 to Cross Bar A7 using Screws B6, please note holes are per-drilled. STEP 6 B1 z= PCs B2 «to @sets Attach Top Panel Al to Side Panels using Wood Dowels Bl and Cam Locks (B2).
STEP 7 B6 Om PCs Attach Back Panel A8 to the back of the unit using Screws B6.
