ASSEMBLY INSTRUCTIONS Style # WR1340 Wine Rack NOTE TO CUSTOMERS: For ease and speed of assembly we recommend that before you commence each step of the assembly that you identify all the parts required to complete that step. ‘We recommend that where possible you allow sufficient space to assemble the item as close as possible to the place where it will be once assembled. For the protection of your furniture we recommend that the product is placed on protected surfaces during assembly to prevent any damage.
To insert a cam lock: (Please read below instructions before assembling) T [E]] = [5] T Diagram A wa a” Diagram C Tae va 1. Insert cam screw into hole as shown in diagram A . Make sure not to insert the cam screw: Too deep as shown in figure B as this will cause the cam screw to be misaligned and unable to interlock properly. Also avoid inserting the cam screw too close to the surface of the hole as shown in figure C, as this will cause the cam lock to be too loose, and not interlock properly.
1. WARNING: . Place heaviest items in the lowest drawers . Unless specifically designed to accommodate, do wot set televisions or other heavy objects on top of this product. . ‘Never allow children to climb or hang on drawer,doors,or shelves. . Never opes more than one drawer at a time (OR) . Do mot defeat or remove the drawer interlock system. Serious or fatal crushing injuries can occur from furniture tip-over.
Hardware List Bl Quantity [B2 Quantity |B3 Quantity |B4 Quantity gon CBE Cam lock Screw Screw Knob with Bolt BS Quantity |B6 Quantity | B7 Quantity| BS. Quantity Anti-tip Kit Shelf Support Magnet with Screw ‘Wood Dowel BI. Quantity of 1 Anchor with Screw Bl: aC tp@ SETS | STEP-1 e 1). Assemble Magnets B6 to Divider Panels using included screws. 2). Assemble Divider Panels to Center Shelf Al using Cam locks B1 and Wood Dowels B7.
Bl: m_®@ SETS | B7: ezm PCS a STEP-2 FRONT 1). Assemble Bottom Panel A3 to Divider Panels using Cam locks B1 and Wood Dowels B7. 2). Screw Support Leg A10 to the bottom of Bottom Panel A3 ag shown above. Please do not keep-turning leg A10, STEP-3 Assemble Side Panels to Bottom Panel A3 using Cam locks B1 and Wood Dowels B7.
SETS STEP-4 PCS | FRONT Assemble Top Panel AS to Side Panels and Divider Panels A2( R&L) using Cam locks B1 and Wood Dowels B7. STEP-5 B2: T 22pCS Assemble Back Panel A6 to Bottom Panel A3 & Side panels & Top panel A5 & Dividers using Screws B2.
STEP-6 A7 Cross A7 Panels and then put them into the center of this wine rack. STEP-7 Insert Shelf Support B5 into the holes of Side Panels and Divide Panels A2 then put Removable Shelves A9 onto Shelf Support BS.
STEP-8 ! B3: @m8PCS Doors with hinges to Side Panels using Screws B3. Knobs B4 onto doors with including bolts.
For you safety, please attach this unit to the wall by the plastic anchors with screw B8 and Anti-tip Kit BY. APPENDIX: Dimension of Hardware in this AI Bl. B2.
