User manual

SIGNUM SYSTEMS
830
- RAM for the flash programmer, 16k@0x0.
-no-flash-write - Restrict flash write to context defined by commands
monitor flash before-load and
monitor flash after-load.
Examples
CONNECT TO THE IMX31 PROCESSOR (VERBOSE VERSION)
sigGdbServer -emu iMX31.par -init iMX31.ini
CONNECT TO THE IMX31 PROCESSOR
sigGdbServer -cpu iMX31 -init
This is a short version of the previous command line. The processor is
specified using the –cpu iMX31 option. The emulation parameter file
iMX31.par will be used if present. The –init option without a file name will
use the iMX31.ini file if present.
CONNECT TO THE IMX31 PROCESSOR, LOAD PERIPHERAL REGISTERS
sigGdbServer -cpu iMX31 -init –reg iMX31
Additional peripheral register definitions will be loaded from the
targets\iMX31.def file.
CONNECT TO THE IMX31 PROCESSOR WITH A NOR FLASH AT 0XA000_0000
sigGdbServer -cpu iMX31 –init \
-flash cfi@0xA000_0000 –ram 16k@0x1FFF_C000
CONNECT TO THE LUMINARY MICRO LM3SXXX PROCESSOR WITH AN INTERNAL
FLASH
sigGdbServer -emu LM3S.par \
-flash LM3S -ram 2k@0x20000000
CONNECT TO ATMEL AT91SAM3 PROCESSOR WITH AN INTERNAL FLASH
sigGdbServer -cpu ARM7TDMI -flash SAM7S
CONNECT TO ST MICROELECTRONICS STM32 PROCESSOR WITH A 512KB INTERNAL
FLASH
sigGdbServer -cpu STM32 –init \
-flash STM32@0x08000000,size=512 -ram 32k@0x20000000
CONNECT TO THE TOSHIBA TMPM3XX PROCESSOR WITH AN INTERNAL FLASH
sigGdbServer -cpu CORTEX-M3 \
-flash TMPM3,TMPM330FDFG -ram 32k@0x20000000
CONNECT TO THE NXP LPC17XX PROCESSOR WITH AN INTERNAL FLASH
sigGdbServer -cpu Cortex-M3 -flash LPC
CONNECT TO THE NXP LPC2XXX PROCESSOR WITH AN INTERNAL FLASH RUNNING
AT 12MHZ
sigGdbServer -cpu ARM7TDMI-S -flash LPC,f12000
4