Installation guide

4
Connect the Full-HD Digital Signage Player to your network
Enter Network setting in the menu to set up a network connection method.
Wireless connection (CE-DS0111-S1 only)
The player will scan for wireless signals nearby
during boot up. If the network requires
authentication, you will be asked to provide the
password for access.
Wired connection
To use the wired Ethernet connection, connect an Ethernet cable and the
Wi-Fi (CE-DS0111-S1) will be disabled.
Player IP address
You will also need an IP address for the player on your network. This could
be set automatically (DHCP) or manually (static IP):
DHCP – automatically assign network IP address
DHCP is enabled by default. You do not need to change the settings unless
setting a static IP.
Static IP – manually assign network IP address
Highlight IP configuration and press Enter on keyboard to <Select>
Move the highlight to Static IP below, press Space bar on the keyboard to
fill in the star (*) at the Static IP brackets, and press Enter on the keyboard
to select <OK>.
Proceed to configure an available static IP address. Select Wireless
configuration or IP configuration as determined by your connection. Please
consult your network administrator for assistance if necessary.