Installation guide

Dip Switch

• Default Mode: 1080p video and 7.1ch surround

sound audio. If your HDTV shows video without

audio, set DIP switch to Safe Mode

• Safe Mode: 1080p and stereo output. This setting

does not support an HDMI source set to outpu

1080p resolution. Set the HDMI source's output to

any resolution less than 1080p or "Auto"

• EDID Learning / EDID Learning & Stereo Mode:

Power off the Transmitter. Connect your HDTV to

the Transmitter's HDMI Output via HDMI cable,

then set pin-1 at On. Power on the Transmitter and

HDTV, wait 5~10 seconds to complete the EDID

learning process. To learn the EDID from another

HDTV, repeat this procedure

NOTE: Bypass mode may cause compatibility

issues when mixing HDMI sources and HDMI

displays. If you cannot get satisfactory audio and/

or video output, set the DIP switch to Default

Mode or Safe Mode.

Table 1: DIP Switch Position

DIP Switch Position

Video Audio Description

Pin 1 Pin 2

Off Off Up to 1080p Surround Default Mode

Off On Up to 1080p Stereo Safe Mode

On Off Bypass Bypass EDID Learning Mode

On On Bypass Stereo EDID Learning & Stereo Mode