Installation guide

• RS-232: RS-232 control port. Plug the included

3.5mm to RS-232 cable then an RS-232 cable here, if

needed

• HDMI IN: HDMI signal input port. Connect this

port to your HDMI source device by using an HDMI

cable (not included)

• HDMI OUT: HDMI signal output port. Connect

this port to a local HDMI display by using an HDMI

cable (not included)

• LINE : Signal output port, connected with Receiver's

LINE port by using a CAT X cable (not included)

• IR: Connect to the included IR blaster cable

• RESET: Use the fine end of any object to press and

hold the bottom to return to default settings

Receiver / Repeater Unit (Rx)

Figure 2: Receiver/Repeater side panel

• DC 5V: DC 5V power jack. Plug the included power

adapter here

• IR: Connect to the included IR receiver cable

• RESET: Use the fine end of any object to press and

hold the bottom to return to default settings