Installation guide

6
6. Connect the two 3.5mm to RS-232 cables to the
Transmitter and Receiver's RS-232 ports respectively.
Skip this step if RS-232 control is not needed.
7. Connect your CAT5/6 cable between the
Transmitter's and Receiver's LINE port. Make sure
the CAT5/6 LAN cable is securely connected.
Figure 6
remote
output
display
source
device
8. Each Receiver/Repeater can cascade-daisy chain to 2
or more Receivers/Repeaters for extending or
expanding. Skip this step if extending is not needed.
9. Plug the included power adapters into the DC 5V
power jack of the Transmitter and Receiver separately.
Power on the connected display(s), the Extender kit is
ready for use.
local
output
display
CAT5/
6 cable