sic 4-Port HDMI 2.0 4K HDR Smart Console Switch with USB 3.
Goo A\ Safety and Notice The device has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipment, the device should be used with care, Please read and follow the safety instructions to protect yourself from possible injury and to minimize the risk of damage to the unit. Follow all instructions and warnings marked on this unit. Do not attempt to service this unit yourself, except where explained in this manual.
-Features « HDMI 2.0a compliant + Supports 4K2K@60 4:4:4 bits, Video bandwidth 18Gbps + Supports HDR, which is 4K2K@60 4:2:0 bits « PHD 2.2 and 1.4 compliant + Support separate line input and output + Plug and Play without any driver needed « Supports built-in 4-part USB 3.
oc Layout Front Panel 1. Port 1-4 Selection Push Button: Switch between computers 2. USB 3.0 Hub: Connect to USB devices Rear Panel 3. Console USB Ports: Connect to keyboard & mouse 4. KVM Video IN 1-4: Connect the HDMI cable to PC 5. Console Video OUT: Connect the HDMI cable to a display 6. +12V DC: +12V DC power jack 7. Power Status: Power indicator LED 8. Micro USB: For F/W update 9. USB 3.
oc Dip Switch PINT ON[$] KVM firmware update mode OFFICE] | Working mode firmware update mode PIN#2 OFF[#] | Working mode.
oc Hotkey Default setting, all of the following commands begin by pressing the [Scroll Lock] key twice.
oc Firmware update Firmware update is proceeded through Micro-USB KVM F/W update 1. 2, Connect the Micro-USB to USB cable between PC and device Set dip switch PIN#1 to ON[$] and then power on device Open firmware update software and then select COM Port Click “KVM” button to open "KVM Firmware Update” windows Check all items and click each button to select the file which you want to write into device.
oc MCU F/W update 1. 2. Connect the Micro-USB to USB cable between PC and device Set dip switch PIN#2 to ON[#] and then power on device Open firmware update software and then select COM Port Click “MCU” button to open “MCU Firmware Update” windows Click “Load File” button to select the file which you want to write into device.
