Installation guide

4
4. Attach the other end of the SATA data cable to the
internal Serial ATA connector.
5. Replace the computer cover and reconnect the power
cord.
External Serial ATA port
External Serial ATA hard disk drives should come with
their own accessories. In most cases, you just need to
power up the external drive and connect it to the external
port. For more information, please refer to the external
device's manual.
Driver Installation
This section provides information on how to install the
eSATA II PCIe i/e drivers.
Windows 2000
New Installation
A new installation of Windows 2000 requires a floppy
disk for the driver installation. To make this floppy disk,
copy the contents of the Floppy folder, found on the
driver CD, onto a blank floppy disk then follow the
directions below.
1. Install the board and follow Microsoft procedures
to install Windows accordingly.
2. Restart your system if prompted during Windows
installation, otherwise, go directly to step 3.
3. At the Windows 2000 Setup screen, press F6 to
install the driver.
4. Insert the driver diskette. Press S, then press Enter.
5. Select Silicon Image SiI 3132... Controller for
Windows 2000 and press Enter.