Installation guide

7
Existing Installation
1. Install the board and boot up Windows.
2. At the Found New Hardware Wizard:
XP (w/SP1 or earlier)/Server 2003: continue to step #3.
XP (w/SP2 or later)/Server 2003 (w/ SP1 or later): select
No, not this time, then click Next.
3. Insert the driver CD, select Install the software
automatically (Recommended), then click Next.
Note: Most systems will install the driver
automatically after inserting driver CD.
4. Click Finish. Remove the driver CD and restart
Windows to complete the installation.
To Verify Windows 2000 / XP / Server 2003 Installation
1. Right click My Computer and click Manage.
2. Select Device Manager.
3. Double click SCSI and RAID Controllers, Silicon
Image SiI 3132... Controller should be displayed.
Windows Vista™ (32-bit)
New Installation
1. Install the board and follow Microsoft procedures
to install Windows accordingly.
2. At Where do you want to install Windows?, click
Load Driver.
3. Insert the driver CD, then click Browse.
4. Double click CD Drive... Drivers.
5. Highlight the Floppy folder, then click OK.
6. Select Silicon Image SiI 3132... Controller, then
click Next.