Installation guide

2. At the next screen select Create RAID Set, then

press Enter.

3. Select Concatenation, then press Enter.

4. Select 2, then press Enter.

5. Select one hard disk drive, then press Enter.

6. Select the second hard disk drive, then press Enter.

7. When asked Are You Sure (Y/N)?, press Y to accept.

Note: In the RAID BIOS screen, under Logical Drive,

SiI Concatenation and the size of the logical drive

will appear.

8. Press Ctrl+E to exit the BIOS.

9. When asked Are you sure to exit (Y/N)?, press Y to

exit and reboot.

Note: When two drives are combined using JBOD,

each hard disk drive will appear as Concatenated

in the SATARAID5 GUI.

Rebuilding a Failed Mirror Set

When a failure to one member occurs, you will be notified

either by the RAID BIOS during boot or by the SATA

Raid5 GUI while in Windows. The steps below will

guide you in rebuilding a failed mirror set.

For Offline Mirror Rebuild (SATA RAID BIOS)

1. Replace the failed drive with one of equal or greater

capacity, then start the computer.

2. During boot press Ctrl+S or F4 to enter the RAID

BIOS.

3. Select Create RAID Set, then press Enter.

4. Select SPARE DRIVE, then press Enter.

5. Select the single hard drive then press Enter.