Installation guide

9
6. Input the RAID size, press Enter. When asked Are
You Sure (Y/N)?, press Y to confirm.
7. Select Rebuild Raid 1 Set, press Enter.
8. When asked Are you sure (Y/N)?, press Y confirm.
The mirror will begin rebuilding. Do not interfere
with the process.
9. When rebuilding is finished, press Ctrl+E.
10. When asked Are you sure to exit (Y/N)?, press Y to
exit and reboot.
For Online Mirror Rebuild (in Windows)
1. Replace the failed drive with one of equal or greater
capacity, then start the computer.
2. When Windows resumes, at the SATA SoftRaid 5
screen, click Legacy Support, then click Rebuild
Legacy RAID Group.
Note: If Legacy Support does not show, click File,
Configuration, Advanced Options. Check Legacy
(Bootable) Support, then click OK.
3. At Rebuild Legacy RAID Group box, select both
hard drives, then click Rebuild.
4. Click OK, then click Cancel to close the window.
5. The mirror will rebuild. Rebuild time is dependant on
the size of the mirror set.
Deleting RAID Arrays
1. As the BIOS boots press Ctrl+S or F4 when prompted
to enter the RAID BIOS.
2. Select Delete RAID Set, then press Enter.
3. Select the RAID set, then press Enter.
4. When asked Are You Sure (Y/N)?, press Y to confirm.