Installation guide

4
Static Electricity Discharge may permanently
damage your system. Discharge any static
electricity build up in your body by touching your
computer case for a few seconds. Avoid any
contact with internal parts and handle cards
only by their external edges.
1. Turn OFF the power to your computer and
any other connected peripheral devices.
Unplug the computer's power cord.
2. Remove your computer cover and install
the card in an available PCI slot.
3. Push the board down firmly, but gently,
until it is well seated.
4. Connect an available 4-pin power
connector from the system power supply to
the 4-pin power connector on the FireWire
800 32-bit PCI board (See Figure 1 on page
3). This connection is recommended for
consistent power output from the FireWire
port.
5. Secure the card and replace the cover.