Installation guide

3
FireWire (1394a)
USB 2.0
Gigabit
Ethernet
Power Connector
(Optional)**
Layout
Figure 1. Board Layout
*NOTE: The Wake-On-LAN (WOL) feature is optional
and not needed in many cases. If you want to use this
feature, the system's motherboard has to have a 3-pin
WOL connector onboard. Follow the directions below to
enable this feature.
1. Connect one end of the WOL cable to the board's
WOL connector.
2. Connect the other end of the WOL cable to the
motherboard's WOL connector.
3. In the BIOS Power Management, enable the Wake
on LAN or LAN Wakeup option
**NOTE: This power connector (same as the one used
with your floppy disk drive) is designed to provide
additional power to the board when needed. This
connection is optional and not needed in many cases. We
recommend to connect this power connector when 1) all
ports are used, or 2) devices are not being detected.
Wake-On-LAN
(optional)*