Installation guide

2) Software Installation

To ensure proper installation of this board, please follow

these instructions step-by-step.

2-1) Windows 98SE Driver Installation

1. Install the board, boot up your system, and insert

the driver CD.

2. At the Add New Hardware Wizard window, click

Cancel.

3. Click Start, Run, type in X:\setup.exe, then click

OK. (Change X: to match your CD-ROM drive

letter)

4. Choose Yes, I want to restart my computer now,

then click Close to restart Windows.

5. When the PCI standard PCI-to-PCI bridge is

detected, click Next.

6. Choose Search for the best driver..., then click Next.

7. Clear all boxes, then click Next.

8. Click Next, then Finish.

9. When the PCI Ethernet Controller is detected,

click Next.

10. Choose Search for the best driver..., then click Next.

11. Choose Specify a location, type in X:\LAN\win98,

then click Next. (Change X: to match your CD-ROM

drive letter)

12. Click Next.

NOTE: If prompted for Windows 98SE Installation

CD, click OK. Insert this CD and click OK.

13. Click Finish, then No when asked to restart.

14. At the Add New Hardware Wizard window, click

Next.