Installation guide

6
15. Choose Search for the best driver..., then click Next.
16. Clear all boxes, then click Next.
17. Choose The updated driver (Recommended), then
click Next.
18. Click Next, then Finish.
19. Repeat steps 14-18 two more times.
20. Click Yes to restart to complete.
2-2) Windows ME Driver Installation
1. Install the board, boot up your system, and insert
the driver CD.
2. At the Add New Hardware Wizard window, click
Cancel.
3. Click Start, Run, type in X:\setup.exe, then click
OK. (Change X: to match your CD-ROM drive
letter)
4. Choose Yes, I want to restart my computer now,
then click Close to restart Windows.
5. When the PCI standard PCI-to-PCI bridge is
detected, choose Automatic Search for a better
driver (Recommended), click Next, then Finish.
6. When the 1394 Host Controller is detected, choose
Automatic Search for a better driver
(Recommended), click Next, then Finish.
7. When the PCI Ethernet Controller is detected,
choose Specify the location of the driver
(Advanced), then click Next.
8. Check Specify a location, then type in X:\LAN\ME.
(Change X: to match your CD-ROM drive letter)