Installation guide

7
9. Choose The updated software (Recommended)
and click Next.
10. Click Next, then Finish.
11. Click Yes to restart Windows to complete.
NOTE: If prompted to restart Windows again after
a restart, click Yes.
2-3) Windows 2000 Driver Installation
1. Install the board, boot up your system, and insert
the driver CD.
NOTE: If you have Windows 2000 with Service
Pack 4 (SP 4) or later, skip to step 5.
2. At the Add New Hardware Wizard window, click
Cancel two times.
3. Click Start, Run, type in X:\setup.exe, then click
OK. (Change X: to match your CD-ROM drive
letter)
4. Choose Yes, I want to restart my computer now,
then click Close to restart Windows.
5. When the Ethernet Controller is detected, click
Next.
6. Choose Search for a suitable driver for my device
(recommended), then click Next.
7. Check Specify a location, clear the other boxes, then
click Next.
8. Type in X:\LAN\Win2K, then click OK. (Change
X: to match your CD-ROM drive letter)
9. Click Next, then Finish.
10. Restart Windows to complete.