Installation guide

2-4) Windows XP Driver Installation

1. Install the board, boot up your system, and insert

the driver CD.

NOTE: If you have Windows XP with Service Pack

1 (SP 1) or later, follow steps 7-9 only and ignore the

rest.

2. At the Add New Hardware Wizard window, click

Cancel two times.

3. Click Start, Run, type in X:\setup.exe, then click

OK. (Change X: to match your CD-ROM drive

letter)

4. Choose Yes, I want to restart my computer now,

then click Close to restart Windows.

5. When the NEC PCI to USB Enhanced Host

Controller is detected, choose Install the software

automatically (Recommended).

6. Click Next, then Finish.

7. When the Ethernet Controller is detected, choose

Install from a list or specific location (Advanced),

then click Next.

8. Check Include this location in the search, and clear

the Search removable media (floppy, CD-ROM)

box.

9. Type in X:\LAN\XP, click Next, then Finish.

(Change X: to match your CD-ROM drive letter)

10. When the USB 2.0 Root Hub Device is detected,

choose Install the software automatically

(Recommended).

11. Click Next, then Finish to complete.