Installation Manual

4
Figure 4: Rear Panel
• DC 5V: Connects to the included 5V DC power
adapter
• OUTPUT UTP/STP: Plug your CATx cable into this
port, up to 80 meters maximum
• EQ: Press the EQ button to adjust for the length of
the CATx cable
Hardware Installation
1. Connect your CATx cable to the OUTPUT UTP/
STP port of the Transmitter and the Receiver.
2. Plug your USB device(s) into the Receiver's Type A
USB port.
3. Plug the included USB 2.0 Type A to Type A cable
into the Transmitter's USB Input port, then plug the
other end into your computer.
EQ
DC 5V
OUTPUT
UTP/STP
• Power LED: On when the Transmitter is powered
on