Installation guide

4
In order for the USB 3.0 4-Port Hub to work as a
USB 3.0 hub, the driver for your existing USB 3.0
host controller has to be properly installed. This
hub will automatically be detected and installed
when connected to the USB 3.0 port.
1. Connect the Type-B connector of the
included USB 3.0 cable to the Upstream
port (Root Port, Type-B) of the USB 3.0
4-Port Hub.
2. Plug the Type-A connector of the included
USB 3.0 cable into an available USB port
(USB 3.0 recommended) of the computer,
and the driver will install automatically.
3. Connect the included power adapter into
the Power Jack of the USB 3.0 4-Port Hub,
then plug the power adapter into a reliable
power source. The power adapter is optional
but recommended when all four USB ports
4. The USB 3.0 4-Port Hub is ready for use.