Installation guide

Hardware Installation

1. Make sure the SATA connectors of the Cool Dual

SATA to USB 2.0 Docking and the SATA hard disk

drive are in alignment. Carefully insert the SATA

hard disk drive into the SATA drive slot.

2. Plug the included switching power adapter into

the power adapter jack ot the Cool Dual SATA to

USB 2.0 Docking, then plug the switching power

adapter into a reliable power source.

3. Use the included USB 2.0 cable to plug the Cool

Dual SATA to USB 2.0 Docking into the computer.

4. Switch on the Cool Dual SATA to USB 2.0 Docking,

make sure that the 3 Power LEDs are lit.

Note: Do not insert or remove a hard disk drive

when the Cool Dual SATA to USB 2.0 Docking is

powered on.

Go to Driver Installation below to complete the

installation.

Driver Installation

Windows and Mac operating systems will automatically

detect and install drivers for the Cool Dual SATA to USB

2.0 Docking. No additional driver installation is needed.

Note: In order to get high speed USB 2.0

performance, make sure your USB 2.0 controller

has the correct drivers installed.