Installation guide

4
Using the Cool Dual SATA to USB 2.0 Docking
Windows
One drive icon for each inserted hard disk drive will
appear in Computer or My Computer when the Cool
Dual SATA to USB 2.0 Docking is plugged into a USB
port. The drive(s) act just like a conventional hard disk
drive in your system.
Note: Be careful not to touch the hard disk drive
while in use. It will be warm.
Disconnecting From The Computer
Important: Do not insert or remove a hard disk drive
from the Cool Dual SATA to USB 2.0 Docking while
powered on, doing so will damage the hard disk drive.
Before unplugging the Cool Dual SATA to USB 2.0 Docking
from the computer, it must first be stopped, by using
Windows Safely Remove Hardware feature. Follow
the steps below for your version of Windows. The same
rule applies when turning off the Cool Dual SATA to USB
2.0 Docking. Not following the instructions may result in data
corruption, data loss, or damage the hard drive.
Windows 7
1. Verify that the HDD LED(s) are OFF before
proceeding.
2. In the system tray by the system clock, click Show
hidden icons, then click the Safely Remove
Hardware and Eject Media icon.
3. Click USB Mass Storage Device.
4. At Safe to Remove Hardware confirmation box,
you can unplug or turn off the Cool Dual SATA to
USB 2.0 Docking.