Installation guide

2. During boot press Ctrl+S or F4 to enter the RAID

BIOS.

3. Select Create RAID set then press Enter.

4. Select SPARE DRIVE then press Enter.

5. Select the replacement drive then press Enter.

6. When asked Are You Sure (Y/N)?, press Y to confirm.

7. Press Ctrl+E to exit.

8. When asked Are you sure to exit (Y/N)?, press Y to

exit.

Note: If during restart the RAID BIOS reports an

incomplete RAID set, disregard the message,

continue booting, and let the Mirror rebuild.

Single Drive Setup

Setting up a hard drive to operate as a single drive may

destroy all existing data on the hard drive, therefore, back

up any data on the hard drive before connecting it to the

RAID controller or use a blank or new hard drive.

1. As the BIOS boots press Ctrl+S or F4 when prompted

to enter the RAID BIOS.

2. At the next screen select Create RAID Set, then

press Enter.

3. Select Concatenation, then press Enter.

4. Select 1, then press Enter.

5. Select the hard drive, then press Enter.

6. When asked Are You Sure (Y/N)?, press Y to accept.

Note: In the RAID BIOS screen, under Logical Drive,

SiI Concatenation and the size of the logical drive

will appear.

7. Press Ctrl+E to exit the BIOS.