Installation guide

8. When asked Are you sure to exit (Y/N)?, press Y to

exit and reboot.

Note: The hard disk will show up as Contiguous in

the SATARAID5 GUI.

JBOD Drive Setup

This RAID Array combines the full capacity of two or

more hard drives to form one logical drive. Since this

configuration will destroy all existing data on each hard

drive, use blank or new hard drives or back up the

existing data before connecting to the raid controller.

1. As the BIOS boots press Ctrl+S or F4 when prompted

to enter the RAID BIOS.

2. At the next screen select Create RAID Set, then

press Enter.

3. Select Concatenation, then press Enter.

4. Select the number of drives, then press Enter.

5. Select each hard drive, then press Enter in succession.

6. When asked Are You Sure (Y/N)?, press Y to accept.

Note: In the RAID BIOS screen, under Logical Drive,

SiI Concatenation and the size of the logical drive

will appear.

7. Press Ctrl+E to exit the BIOS.

8. When asked Are you sure to exit (Y/N)?, press Y to

exit and reboot.

Note: When multiple drives are combined using

JBOD, each hard disk drive will appear as

Concatenated in the SATARAID5 GUI.